Thread: mbarcode
View Single Post
Wikiwide is offline Wikiwide
2010-08-11 , 09:25
Posts: 2,006 | Thanked: 3,351 times | Joined on Jun 2010 @ N900: Battery low. N950: torx 4 re-used once and fine; SIM port torn apart
#429
Originally Posted by lardman View Post
Right, I Debian-ised it and did a compile, I've attached the whole tarball here. It also contains output.txt which should show you the commands that were executed to get it to build.

Have a look and see if that's of use.
Hmm... It's strange, but the .so which was built and packed into this .tar.gz, still gives this message "Could not load" when I run mbarcode from terminal. Even though I have given full r+w+x permissions to the .so.

It seems that this stubborn cpp is ready to ruin even qmake magic in order to prove that its impossible to build a module from it...

I'll continue to look at the qr-code plugin: maybe, there is a hint because the qr-code plugin works fine.