Thread
:
[Announce] VICaR: Value International Call Router (Calling Card Helper)
View Single Post
benaranguren
2010-11-08 , 01:46
Posts: 17 | Thanked: 13 times | Joined on Dec 2009
#
150
First off thanks for VICar. It's been really useful for me.
I was also getting the same error as m_dk29
VICaR - Invalid request. Phone Number is not valid
dbus-monitor reveals that VICaR is trying to call 'publish' and 'subscribe' which are both non-numeric, hence the error.
I am new to telepathy so I am sharing info below hoping that somebody would correct me if I am wrong
After reading TP documentation I learned that both publish and subscribe have special purpose.
publish: get contacts to push presence info to
subscribe: get contacts to pull presence info from
Both do not apply to VICaR since it doesn't really connect to a server.
With that knowledge, I went ahead and updated 0.5.1 (only source in garage). If number to call is either 'publish' or 'subscribe' then don't forward request to callrouter.
I guess another way to do is by checking value of HandleType. It should always be 1 (Contact).
I don't see error message anymore but I think it just masks the problem. What really initiated request for 'publish' and 'subscribe' list?
Thanks again for the app!
Quote & Reply
|
The Following User Says Thank You to benaranguren For This Useful Post:
scifi.guy
benaranguren
View Public Profile
Send a private message to benaranguren
Find all posts by benaranguren