Thread: N900 Will not work in Mass Storage after PR1.3
View Single Post
CraigRobbo is offline CraigRobbo
2010-11-17 , 16:36
Posts: 175 | Thanked: 41 times | Joined on Mar 2010
#32
Originally Posted by James_Littler View Post
If you had actually read the wiki on Updating the tablet firmware you would have come across this section.



To hazard a guess at the windows command, I'd say:
Code:
flasher-3.5 -F <firmware-image> --flash-only=kernel -f -R
If you only want kernel-power v42 then ONLY ENABLE TESTING, I have already explained this.
Each repository holds software, there may be different versions of the same software in each repo.
The higest version of kernel-power to be accepted to testing was v42, therefore you will only get v43+ if you enable the devel repository.
I didnt read the Wiki no. Wasnt aware there was one, but i guess thats my own fault for not looking around (rushing into it)

Anywho, thanks for the help but im unsure where to enter the above commands, do i need some software on my PC to do this?

EDIt i re-read my last post, what i ment was, what sofware that i put on my phone would have caused this?
Im unsure IF any devel software i would have put on it :S

Edit- Just flashed phone to go with a fresh start,. Took all the stuff off of it that i had on so i dont have any devel stuff on there.
Craig

Craig
Last edited by CraigRobbo; 2010-11-17 at 18:32.