Many big thanks for starting this project FRuMMaGe....great work.! I seem to be having difficulty with this and would like some help if someone could explain what i may have done wrong please I have read everything in this forum and gone over it a few times so as to try and not make any big errors(haha)...anyhow.... ...Firstly i have titans power kernel v42...i use queen beacon to enable/disable my o.c (i use ideal 250-850) (whilst trying this out i disabled power settings and reverted to stock). i have python already installed i have sudsser installed and aricrack(v1.03) and the bleeding edge wl1251 drivers....i then installed faircrack(v2) and the old hildon. i tried your old ping file to launch but had no look getting the icon onto the desktop so i used the xterminal method sh /home/user/MyDocs/FAS/launch.sh that opened the gui but a lot of the buttons were grayed out and i started to get many error messages in the xterminal.... ls: /home/user/MyDocs/FAS/cap?WEP/*,cap: No such file or directory Usage: basename FILE (SUFFIX) .......................... Then after i select Monitor in the gui and select injection/ monitor mode i get the following type of messages: insmod: error inserting 'cfg80211.ko': -1 Invalid parameters insmod: error inserting 'mac80211.ko' -1 Unknown symbol in module and many other simular messages ending with wlan0 No such device ifconfig: wlan0: error fetching information: Device not found. And finally if this is of any help the grayed out buttons in the gui are as follows: in monitor: monitor mode "DISABLE" is grayed out in access point: "WEP" START PACKET CAPTURE" "AUTHENTICATE" & "SATRT PACKET INJECTION" grayed out in decrypt: "DECRYPT" is grayed out. any further help would be greatly appreciated EDIT: here is my xterminal messages: