Thread: [Announce] Smartcam Maemo 5 Port - Now with more Qt
View Single Post
handaxe is offline handaxe
2011-03-25 , 15:24
Posts: 1,378 | Thanked: 1,604 times | Joined on Jun 2010 @ Göteborg, Sweden
#28
@azkay: if you don't mind, what is the advantage in using driver=omap.. with gst-launch? I could not see any reduction in cpu use, in fact if anything it increases it, as "omap3camd" kicks in, offsetting any reduction in gst-launch's cpu use. Does hw accel improve framerate?

Originally Posted by azkay View Post
If you hit Stop before closing it, it *should* work.
I was having problems thinking of the best way to close it.
In my testing stop works just fine, the issue arises when the receiver disconnects, smartcam goes away without tidying up. Ideally, the gui should not disappear if tcp crashes, but revert to the gui with the "stop" button changed to "start". I assume this is what you meant by there being no error checking?
Last edited by handaxe; 2011-03-25 at 15:32.