I hope there is someone that could tell me how to correct this. I have supplied as much information as I could find.

Let me tell what I have tried.

Test environment:
* Nokia 770 (3.2005.51-13)
* Router - Linksys WRT54GSV4

When I set the router to 802.11b only my connection works fine. When I switch the router to 802.11g only or 802.11b/g I can not get a connection from the 770.

At first I thought that it was the router (even though my laptop works with the router under all settings). I tried the same thing with a Netgear router and experienced the same problem when the router was set to g. I also tried connecting to other routers at various hot-spots, the connection only works with routers set to b only. Most places where I want to use the connection have their routers set to g or b/g so it is important for me to get this working.

I also tried to disable security on the router but it did not help.

This is what happens when I try to connect to a router that is set to b/g (mixed mode):

* The router is identified, the SID is shown and the signal is strong (I sat close to the router).
* I select the router and the W flashes for a few seconds and then shows it is connected.
* When I look at the IP assigned I see that it did not connect
(169.254.178.242 default router 0.0.0.0).

Here is the dmesg output when I try to connect to the router in mixed mode:
[ 601.337280] Loading 3825.arm firmware
[ 602.149200] CX3110x: MAC address xx:xx:xx:xx:xx:xx (I removed the detail)
[ 602.318908] No power saving
[ 604.741210] Scan complete, scanned 11 channels
[ 619.193908] No power saving
[ 619.537384] Scan complete, scanned 11 channels
[ 619.641784] No power saving
[ 619.642333] No power saving
[ 620.982330] We wake up for DTIMs
[ 648.414245] autoipd uses obsolete (PF_INET,SOCK_PACKET)
[ 731.493011] hwa742: setting update mode to disabled
[ 731.493072] hwa742_notifier_cb(): event = DISABLED
[ 772.761566] hwa742: setting update mode to manual
[ 772.761596] hwa742_notifier_cb(): event = READY


Here is the dmesg output when I connect to the router in b mode only:
[ 1100.197875] Loading 3825.arm firmware
[ 1101.108398] CX3110x: MAC address xx:xx:xx:xx:xx:xx (I removed the detail)
[ 1101.280090] No power saving
[ 1103.703186] Scan complete, scanned 11 channels
[ 1106.212493] No power saving
[ 1106.509826] Scan complete, scanned 11 channels
[ 1106.552886] No power saving
[ 1106.553344] No power saving
[ 1107.888732] We wake up for DTIMs
[ 1175.946136] hwa742: setting update mode to disabled
[ 1175.946197] hwa742_notifier_cb(): event = DISABLED