![]() |
2009-12-02
, 12:02
|
Posts: 268 |
Thanked: 304 times |
Joined on Oct 2009
@ Orlando, USA
|
#2
|
47946.744060] usb 5-2: new full speed USB device using uhci_hcd and address 8 [47946.868064] usb 5-2: device descriptor read/64, error -71 [47947.148056] usb 5-2: device descriptor read/64, error -71 [47947.308100] hub 5-0:1.0: unable to enumerate USB device on port 2 [47952.868063] usb 1-8: new high speed USB device using ehci_hcd and address 16 [47953.001490] usb 1-8: configuration #1 chosen from 2 choices [47953.013522] cdc_acm 1-8:1.6: This device cannot do calls on its own. It is not a modem. [47953.013701] cdc_acm 1-8:1.6: ttyACM1: USB ACM device [47953.021625] usb0: register 'cdc_ether' at usb-0000:00:1d.7-8, CDC Ethernet Device, 2a:b9:03:f7:68:92 [47961.177358] usb 1-8: USB disconnect, address 16 [47961.433756] usb0: unregister 'cdc_ether' usb-0000:00:1d.7-8, CDC Ethernet Device [47962.492105] usb 1-8: new high speed USB device using ehci_hcd and address 17 [47962.626303] usb 1-8: configuration #1 chosen from 2 choices [47962.638372] scsi5 : SCSI emulation for USB Mass Storage devices [47962.638609] usb-storage: device found at 17 [47962.638615] usb-storage: waiting for device to settle before scanning [47967.637593] usb-storage: device scan complete [47967.639222] scsi 5:0:0:0: Direct-Access Nokia N900 031 PQ: 0 ANSI: 2 [47967.639701] scsi 5:0:0:1: Direct-Access Nokia N900 031 PQ: 0 ANSI: 2 [47967.640522] sd 5:0:0:0: Attached scsi generic sg2 type 0 [47967.640744] sd 5:0:0:1: Attached scsi generic sg3 type 0 [47967.673715] sd 5:0:0:1: [sdc] Attached SCSI removable disk [47967.677055] sd 5:0:0:0: [sdb] 56631296 512-byte logical blocks: (28.9 GB/27.0 GiB) [47967.677715] sd 5:0:0:0: [sdb] Write Protect is off [47967.677718] sd 5:0:0:0: [sdb] Mode Sense: 0f 00 00 00 [47967.677721] sd 5:0:0:0: [sdb] Assuming drive cache: write through [47967.681907] sd 5:0:0:0: [sdb] Assuming drive cache: write through [47967.681914] sdb: [47967.699166] sd 5:0:0:0: [sdb] Assuming drive cache: write through [47967.699176] sd 5:0:0:0: [sdb] Attached SCSI removable disk
sudo fdisk -l
archebyte$ sudo fdisk -l Disk /dev/sda: 160.0 GB, 160041885696 bytes 255 heads, 63 sectors/track, 19457 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes Disk identifier: 0xdea1dea1 Device Boot Start End Blocks Id System /dev/sda1 * 1 5222 41945683+ 7 HPFS/NTFS /dev/sda2 5223 15182 80003700 5 Extended /dev/sda5 5223 14933 78003576 83 Linux /dev/sda6 14934 15182 2000061 82 Linux swap / Solaris Disk /dev/sdb: 29.0 GB, 28995223552 bytes 64 heads, 32 sectors/track, 27652 cylinders Units = cylinders of 2048 * 512 = 1048576 bytes Disk identifier: 0x00000000 Device Boot Start End Blocks Id System
![]() |
2009-12-02
, 12:07
|
Posts: 268 |
Thanked: 304 times |
Joined on Oct 2009
@ Orlando, USA
|
#3
|
Hi guys, having a small issues connecting the N900 to my Ubuntu install. When connected to the machine using mass storage mode. The device does not get mounted. looking at log/messages it reports seeing it as ehci_hcd
Dec 2 10:13:33 computer kernel: [1038738.136785] usb 1-5: new high speed USB device using ehci_hcd and address 11
Any ideas?
Thanks
The Following User Says Thank You to archebyte For This Useful Post: | ||
![]() |
2009-12-02
, 12:10
|
|
Posts: 2,142 |
Thanked: 2,054 times |
Joined on Dec 2006
@ Sicily
|
#4
|
The N900 will not be mounted if files in the MyDocs are open or directories under MyDocs are 'cd' ed into in Xterm.
![]() |
2009-12-02
, 12:13
|
Posts: 102 |
Thanked: 22 times |
Joined on Oct 2009
|
#5
|
Disk /dev/sda: 500.1 GB, 500107862016 bytes 255 heads, 63 sectors/track, 60801 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes Disk identifier: 0xbab9b72c Device Boot Start End Blocks Id System /dev/sda1 * 1 4864 39070048+ 7 HPFS/NTFS /dev/sda2 4865 60771 449072977+ 5 Extended /dev/sda3 60772 60801 240975 83 Linux /dev/sda5 4865 7539 21486906 83 Linux /dev/sda6 7540 9971 19535008+ 83 Linux /dev/sda7 9972 34286 195310206 83 Linux /dev/sda8 34287 35563 10253907 82 Linux swap / Solaris /dev/sda9 35563 60648 201495231 83 Linux /dev/sda10 60649 60771 987966 b W95 FAT32
![]() |
2009-12-02
, 12:44
|
Posts: 268 |
Thanked: 304 times |
Joined on Oct 2009
@ Orlando, USA
|
#6
|
9.04
I dont think i have anything open. Tried straight after reboot as well. Maybe something weird with my ubuntu install. Although never had issues in the past.
![]() |
2009-12-02
, 13:01
|
Posts: 102 |
Thanked: 22 times |
Joined on Oct 2009
|
#7
|
![]() |
2009-12-02
, 13:10
|
|
Posts: 2,669 |
Thanked: 2,555 times |
Joined on Apr 2007
|
#8
|
OK tried all USB ports on PC (excessive I know) no luck.
Tried another ubuntu system at it seems to be working fine. So will try again on this machine after reboot. Can't reboot at the moment too much running.
Weird thing is it did not have all the folders that are listed in the N900 file manager. Is this normal?
![]() |
2009-12-02
, 13:16
|
Posts: 102 |
Thanked: 22 times |
Joined on Oct 2009
|
#9
|
![]() |
2009-12-02
, 13:32
|
Posts: 102 |
Thanked: 22 times |
Joined on Oct 2009
|
#10
|
Dec 2 10:13:33 computer kernel: [1038738.136785] usb 1-5: new high speed USB device using ehci_hcd and address 11
Any ideas?
Thanks