Active Topics
-
List of well performing apps on Leste (35)
to Maemo 7 / Leste by smatkovi - 1 day, 13 hrs ago -
Porting apps to Leste (43)
to Maemo 7 / Leste by teroyk - 1 day, 20 hrs ago -
Sailfish OS for the Motorola Moto G7 Power (XT1955-5) - (ocean) (13)
to SailfishOS by edp17 - 2 days, 11 hrs ago -
Sailfish OS for the Samsung Galaxy Note 4 (SM-N910C) - (treltexx) (79)
to SailfishOS by edp17 - 2 days, 11 hrs ago -
U-Boot for Nokia RX-51 with BootMenu (updated version 2012.10-rc3-1) (843)
to Alternatives by Arno_11 - 2 days, 17 hrs ago -
Maemo repository (5)
to Community by dredlok706 - 5 days, 12 hrs ago -
Re-commissioning N9 in 2018 (127)
to MeeGo / Harmattan by smatkovi - 5 days, 14 hrs ago - more...
|
2010-05-14
, 16:43
|
|
Posts: 163 |
Thanked: 21 times |
Joined on Feb 2010
@ London UK
|
#2
|
Its probably fried the chips for the faulty parts.. Without seeing it unable to tell for sure. I doubt its software tho. Did you immediatly pull out the battery when it got wet, for any other users its best to turn it off if your near water then if it does get wet let it dry out for a week before powering it on.
| The Following User Says Thank You to crsnwby For This Useful Post: | ||
|
|
2010-05-15
, 01:49
|
|
Posts: 2 |
Thanked: 0 times |
Joined on May 2010
|
#3
|
Hi Crsnwby,
Thanks for the comment. I plan to open up the the phone soon and I'll post images if there's any obvious damage.
Are you aware of any utility that checks the health of the wifi module?
Just to add to the initial message, I found an aditional weird behavior: if i shut down after a failed 'Select Connection' screen the phone reboots automatically.
Thanks,
Charles
Thanks for the comment. I plan to open up the the phone soon and I'll post images if there's any obvious damage.
Are you aware of any utility that checks the health of the wifi module?
Just to add to the initial message, I found an aditional weird behavior: if i shut down after a failed 'Select Connection' screen the phone reboots automatically.
Thanks,
Charles
Originally Posted by crsnwby
Its probably fried the chips for the faulty parts.. Without seeing it unable to tell for sure. I doubt its software tho. Did you immediatly pull out the battery when it got wet, for any other users its best to turn it off if your near water then if it does get wet let it dry out for a week before powering it on.
|
|
2010-05-16
, 10:36
|
|
Posts: 86 |
Thanked: 28 times |
Joined on Jan 2010
@ That beer and prezels country in Europe -_-
|
#4
|
I have to second this.
Possibility one would be fried chips or connectors (bad)
Possibility two would be short-circuing due to saltwater being much more conductive than normal water.
The latter can be solved by cleaning the MB with Q-Tips and destilled water (basically erasing every trace of salt or minerals on it).
Possibility one would be fried chips or connectors (bad)
Possibility two would be short-circuing due to saltwater being much more conductive than normal water.
The latter can be solved by cleaning the MB with Q-Tips and destilled water (basically erasing every trace of salt or minerals on it).
|
|
2010-05-16
, 10:49
|
|
Posts: 1,425 |
Thanked: 983 times |
Joined on May 2010
@ Hong Kong
|
#5
|
Originally Posted by Charles Young
Hope this help:
Hi Crsnwby,
Thanks for the comment. I plan to open up the the phone soon and I'll post images if there's any obvious damage.
http://www.youtube.com/watch?v=aVEHm325-z8
 |
|
2010-05-16
, 12:18
|
|
Posts: 70 |
Thanked: 410 times |
Joined on Sep 2009
@ Fife, Scotland.
|
#6
|
Originally Posted by crsnwby
Several points.
Its probably fried the chips for the faulty parts.. Without seeing it unable to tell for sure. I doubt its software tho. Did you immediatly pull out the battery when it got wet, for any other users its best to turn it off if your near water then if it does get wet let it dry out for a week before powering it on.
If a phone gets wet in _clean_ water - would you drink it? - then drying out completely may help.
However.
Saltwater (or indeed coke, or ...) is _much_ nastier - perhaps ten thousand times more conductive, and it never fully dries. Even if you dry it for a week in a warm place, you still don't remove the salt, which when there is the slightest hint of moisture in the air will absorb it, and get damp, and start to conduct.
This causes various effects - the wires on parts of internal circuitry are only a few thousandths of a mm thick, and can easily corrode through.
Corrosion can also add 'leaks' between parts of the circuit that should not be connected together, and cause failures that way.
Some of this is not repairable.
The only reliable way once it's got salt water in to clean it is to immediately pop the battery out - turning it off is not enough - there are plenty of bits still active.
Then dismantle the phone completely, including removing all of the cans, then wash in water with a hint of detergent, followed by a rinse in hot distilled water, then air dry at 80C or so for a few hours.
If this hasn't been done - there is no way of getting the salt out. And it will continue to corrode - even if it's been externally cleaned - or any saltwater just sponged off the motherboard.
However - the above procedure alone risks damaging the phone.
One engineer on these forums with many years of electronics experience broke his n900 while taking it apart.
In short.
Get accidental damage insurance.
|
|
2010-12-26
, 11:37
|
|
Posts: 2 |
Thanked: 1 time |
Joined on Feb 2010
|
#7
|
I have the exact same problem. Had some grime on my screen so i washed the front in front of a running tap. Don't ask me why I did it, I wasn't thinking properly.
I'd imagine that not much water got into the unit. But I have the exact same symptoms as the original poster described.
Did anyone find a solution to this?
I'd imagine that not much water got into the unit. But I have the exact same symptoms as the original poster described.
Did anyone find a solution to this?
|
|
2010-12-26
, 11:59
|
|
Banned |
Posts: 974 |
Thanked: 622 times |
Joined on Oct 2010
|
#8
|
Originally Posted by SpeedEvil
Fresh water can be just as bad on an older device. Old devices are full of salt from your fingers, and this salt together with dirt (which also may contain large amounts of salt) is deposited in cracks around buttons. Fresh water on this will dissolve some of the salt before entering the phone. Water is bad no matter what.
Several points.
If a phone gets wet in _clean_ water - would you drink it? - then drying out completely may help.
However.
Saltwater (or indeed coke, or ...) is _much_ nastier - perhaps ten thousand times more conductive, and it never fully dries. Even if you dry it for a week in a warm place, you still don't remove the salt, which when there is the slightest hint of moisture in the air will absorb it, and get damp, and start to conduct.
This causes various effects - the wires on parts of internal circuitry are only a few thousandths of a mm thick, and can easily corrode through.
Corrosion can also add 'leaks' between parts of the circuit that should not be connected together, and cause failures that way.
Some of this is not repairable.
The only reliable way once it's got salt water in to clean it is to immediately pop the battery out - turning it off is not enough - there are plenty of bits still active.
Then dismantle the phone completely, including removing all of the cans, then wash in water with a hint of detergent, followed by a rinse in hot distilled water, then air dry at 80C or so for a few hours.
If this hasn't been done - there is no way of getting the salt out. And it will continue to corrode - even if it's been externally cleaned - or any saltwater just sponged off the motherboard.
However - the above procedure alone risks damaging the phone.
One engineer on these forums with many years of electronics experience broke his n900 while taking it apart.
In short.
Get accidental damage insurance.
 |
|
2010-12-26
, 12:09
|
|
Posts: 330 |
Thanked: 483 times |
Joined on Dec 2010
@ Norwich, UK
|
#9
|
So to sum up:
Water + Electronics =
Water + Electronics =
__________________
OMNOM: Pacman-like game now in extras-devel
fAircrack (Aircrack GUI): Point-and-click pwnage for your N900
Now with John the Ripper integration
OMNOM: Pacman-like game now in extras-devel
fAircrack (Aircrack GUI): Point-and-click pwnage for your N900
Now with John the Ripper integration
| The Following User Says Thank You to FRuMMaGe For This Useful Post: | ||
|
|
2010-12-26
, 12:42
|
|
Posts: 2 |
Thanked: 1 time |
Joined on Feb 2010
|
#10
|
tried full reflash, wifi still doesnt work. put in the oven for an hour, still doesnt work.
might have to just forgo wifi and 3g access. which is kinda pointless on this phone.
might have to just forgo wifi and 3g access. which is kinda pointless on this phone.
| The Following User Says Thank You to booyah For This Useful Post: | ||
I'm looking for some advice and hopefully you can help me out!
A very tiny amount of seawater entered my N900 through the volume key and possibly the power key last weekend.
The phone was professionally cleaned after that, and is now working fine with the exception of the WiFi and GPRS/3G connectivity.
What happens now is that whenever a 'Select Connection' dialog opens up, it searches for a data stream for a while, then, after quite some time (maybe a minute or so) i get a 'no connection available' and a greyed out option for the GPRS/3G stream.
The funny symptom is that after i close the failed 'Select Connection', some, but not all, of my desktop applications freeze - changing desktops and contacts work, but the 'Conversations' and 'Fm Transmitter' widgets stop working.
So I wonder if (1) my WiFi module is dead (but is GPRS data integrated w/ it?) and (2) if this could be some sort of software fault or file corruption - i had to remove the battery while the phone was on when it got wet.
Could you guys help me out diagnose this issue?
Thanks and all the best,
Charles Young
www.paisagembrasileira.com
P.S.: how do I access the .deb files for the maemo repositories? I'd like to install some health check utilities but have been unable to so far.