Notices
Reply
Thread Tools
jfenton78 is offline jfenton78
2008-02-24 , 21:34
Posts: 14 | Thanked: 0 times | Joined on Jan 2008
#1
I installed the stand alone version of USBControl, but now I can't connect my N800 to my PC. What did I do wrong? What mode does it need to be in? WinXP keeps giving me errors of device not reconized no matter what mode. Thanks for the help.

jf


Update: I selected OTG mode and rebooted. My N800 was recognized just fine. Is this normal operation?
Last edited by jfenton78; 2008-02-24 at 21:42.
 
jfenton78 is offline jfenton78
2008-02-26 , 02:57
Posts: 14 | Thanked: 0 times | Joined on Jan 2008
#2
man, nobody has any advice. can any one tell me if I should have to reboot for changes in uscontrol to take effect? thanks
 
italodance is offline italodance
2008-05-13 , 04:52
Posts: 169 | Thanked: 12 times | Joined on Dec 2007 @ Tehran-Iran
#3
hi nono man

i had this similar problem

listen after install the usb control

if u want to connect ur N800 to the PC,you should go to the usb control and select the OTG mode (on the left side)

yes and u can see the original os2008 usb icon and contact to pc again (everytime u go to there and select an usb position (OTG,HOST,....) it will be defult on ur device)

so if u want to contact it to ur pc it always be on OTG mode

simple

and for other devices like flash drivers,cool disks,HDD....try otg and host and other parts

hope help

__________________
N800 With 2 SDHC CARD's 12 and 4 GB

But Thinking About A 64 GB !!!!

Os 2008 Chinook,I Have't Trust To Diablo!??
Last edited by italodance; 2008-05-13 at 05:09.
 
Reply

« Previous Thread | Next Thread »

 
Forum Jump


All times are GMT. The time now is 14:11.

Contact Us - Home - Archive - Top