Active Topics
-
Firefox with Leste (10)
to Maemo 7 / Leste by teroyk - 2 days, 15 hrs ago - more...
 |
Wasmachinemann-NL |
2022-09-04
, 14:51
|
|
Posts: 386 |
Thanked: 1,094 times |
Joined on Aug 2011
@ Netherlands
|
#1
|
What replacement USB port do I need to replace the worn out one on my N900?
| The Following User Says Thank You to Wasmachinemann-NL For This Useful Post: | ||
 |
|
2022-09-05
, 14:43
|
|
Posts: 1,718 |
Thanked: 4,764 times |
Joined on Apr 2018
@ Helsinki, Finland.
|
#2
|
Maybe you find answers from here. Painful thread for me so not gonna go it through.
https://talk.maemo.org/showthread.ph...maybe+time+usb
https://talk.maemo.org/showthread.ph...maybe+time+usb
__________________
"I don't know how but I can try!" (active)
Master of not knowing (active)
For me it is possible to get lost in any case (active)
Learning to fall from high (DONE)
Learning to code with BASIC (WIP)
"I don't know how but I can try!" (active)
Master of not knowing (active)
For me it is possible to get lost in any case (active)
Learning to fall from high (DONE)
Learning to code with BASIC (WIP)
|
|
2022-09-06
, 10:44
|
|
Posts: 701 |
Thanked: 1,981 times |
Joined on Jun 2015
@ Lisbon - Portugal
|
#3
|
It is a painfull job even for someone with good soldering skills. I will try to solder the wires from a usb cable directly to the board contacts. I believe it will be way easier and it will last more time
| The Following User Says Thank You to deutch1976 For This Useful Post: | ||
|
|
2022-09-07
, 13:44
|
|
Posts: 1,423 |
Thanked: 2,620 times |
Joined on Jan 2011
@ Touring
|
#4
|
Originally Posted by Wasmachinemann-NL
It is(or was) a pretty standard surface mount USB port I have seen that there are two general designs one with the narrow part of the port on the solder pad and the other with the wide part near the pads. I was always able to easily compar the product pictures to my N900's port when ordering.
What replacement USB port do I need to replace the worn out one on my N900?
My best success was to 'tin' up the pads and legs on the port well and then use a heat gun after kapton tape masking everything else on the board especially the camera; solder/flux past is what is supposed to be used with hot air though. I have had to use a soldering iron but that is much harder to do.
Last edited by biketool; 2022-09-07 at 14:29.
| The Following 4 Users Say Thank You to biketool For This Useful Post: | ||
|
|
2022-10-02
, 10:15
|
|
Posts: 386 |
Thanked: 1,094 times |
Joined on Aug 2011
@ Netherlands
|
#5
|
I ended up just grabbing one of my other N900's and BackupMenu-ing it instead.