Active Topics
-
The N900 is now 15 years old! (7)
to Nokia N900 by Danct12 - 3 days, 6 hrs ago -
Sailfish OS for the Motorola Moto G7 Power (XT1955-5) - (ocean) (4)
to SailfishOS by Maemish - 4 days, 2 hrs ago -
F(x)tec Pro1x (QWERTY) for sale (0)
to Buy & Sell by aln00000 - 6 days, 11 hrs ago - more...
|
2013-06-22
, 04:31
|
|
Posts: 1,994 |
Thanked: 3,342 times |
Joined on Jun 2010
@ N900: Battery low. N950: torx 4 re-used once and fine; SIM port torn apart
|
#22
|
Originally Posted by nokiabot
I do wonder whether our local soldering tools are thin enough, but there is hope for a piece of wire to be soldered in place of the broken off pin.
Oh man bad stufffind a local repair shop as hiteb said
as the slot looks it needs dedicate hands to open it up
I do wonder why jewellers don't have a side-business of soldering such thin parts to repair 'broken' devices. Some people around here employ a magnifying glass to take a look at the contacts. I do not have to, because I am near-sighted.
Yes, when seen from above, it looks worse than in previous photographs. But remember. Only one pin is broken off. Other two pins are almost fine, just flattened down. These peeking-holes in metal cover do not show everything within the slot - just ends of the pins.
Thank you. Best wishes.
 |
|
2013-06-22
, 04:44
|
|
Posts: 1,974 |
Thanked: 1,834 times |
Joined on Mar 2013
@ india
|
#23
|
Originally Posted by Wikiwide
yup they will be thin enough
I do wonder whether our local soldering tools are thin enough, but there is hope for a piece of wire to be soldered in place of the broken off pin.
I do wonder why jewellers don't have a side-business of soldering such thin parts to repair 'broken' devices. Some people around here employ a magnifying glass to take a look at the contacts. I do not have to, because I am near-sighted.
Yes, when seen from above, it looks worse than in previous photographs. But remember. Only one pin is broken off. Other two pins are almost fine, just flattened down. These peeking-holes in metal cover do not show everything within the slot - just ends of the pins.
Thank you. Best wishes.
or simply a needle can be used. Better if you go to a electronic servic centere .the pin is easy to repair but the slot mentioned is way too cubersome for me
i remember replacing 5800 and some samgsung slots but yor slot is again diff
i have never seen a n9 or n950 board
good luck with your repairing
 |
|
2013-06-22
, 08:12
|
|
Posts: 1,079 |
Thanked: 1,019 times |
Joined on Mar 2010
|
#24
|
After seeing your latest PIC, it looks like the other 2 pins are not too healthy.
The thing with the adhesive was it was a permanent fix if it wasn't disturbed. Because they were watches in my case the contacts were glued in place, left to cure for a day or two then the battery was replaced and everything was left undisturbed for 12 months minimum until the battery needed replacing.
The thing with the adhesive was it was a permanent fix if it wasn't disturbed. Because they were watches in my case the contacts were glued in place, left to cure for a day or two then the battery was replaced and everything was left undisturbed for 12 months minimum until the battery needed replacing.
__________________
Mick has just punched the cr@p out of the "Unlike" button on the Official Nokia Facebook Page.
Mick has just punched the cr@p out of the "Unlike" button on the Official Nokia Facebook Page.
|
|
2013-06-22
, 12:19
|
|
Posts: 1,994 |
Thanked: 3,342 times |
Joined on Jun 2010
@ N900: Battery low. N950: torx 4 re-used once and fine; SIM port torn apart
|
#25
|
After soldering bits of wire as pins, supported by pieces of two-sided sticky tape so that they would not be flattened, the SIM port works. However, SIM card is not to be taken out, because the whole set-up is fragile.
Torx screws were put back without any troubles. However, there is no wish to remove them while there are no spare screws available.
Best wishes. Thank you.
Torx screws were put back without any troubles. However, there is no wish to remove them while there are no spare screws available.
Best wishes. Thank you.
|
|
2013-06-22
, 14:26
|
|
Posts: 1,994 |
Thanked: 3,342 times |
Joined on Jun 2010
@ N900: Battery low. N950: torx 4 re-used once and fine; SIM port torn apart
|
#27
|
Originally Posted by nokiabot
They fit torx4 screwdriver. Most likely, they are Torx Plus 4, since Service Manual for N9 says Torx+ everywhere.
Good job wikiwide
now will you post a pic of those torx screws as i wonder you may find plenty of them available??
Will post a picture of one of these screws later.
Thank you. Best wishes.
| The Following User Says Thank You to Wikiwide For This Useful Post: | ||
 |
| Tags |
| fixed sim port, hw problem, nokia n950 |
«
Previous Thread
|
Next Thread
»
|
All times are GMT. The time now is 07:17.
as the slot looks it needs dedicate hands to open it up