Notices

[x-nokia.call.missed]
active=true
mce-pattern-name=PatternCommunication

PatternCommunication=30;1;0;4000027f027f02ff02ff027f027f02ff02ff41ff0000

# this hardware has a single-colour LED connected to a NJoy controller
# Please prefix pattern names with Pattern to avoid name space clashes
#
# Priority (0 - highest, 255 - lowest)
# ScreenOn - 0 only show pattern when the display is off
#            1 show pattern even when the display is on
#            2 only show pattern when the display is off, including acting dead
#            3 show pattern even when the display is on, including acting dead
#            4 only show pattern if the display is off, or if in acting dead
#            5 always show pattern, even if LED disabled
# Timeout in seconds before pattern is disabled, 0 for infinite
# Pattern in NJoy format (16 commands at most)
#
# 0000 -- Jump to the start of the pattern for the channel
# 40xx -- Set channel brightness
# xxyy -- Increment/decrement
#      xx determines the speed;
#         01-3f -- short step time (granularity 0.49ms)
#         41-7f -- long step time (granularity 15.6ms)
#      yy determines the increment/decrement steps
#         00-7f -- increment steps 00 = 0 steps, 7f = 127 steps
#         80-ff -- decrement steps 80 = 0 steps, ff = 127 steps
#
#         Use 0 steps to create pauses
#         Two consecutive increment/decrement sequences are needed
#         to cover the entire range from 0-255
# c000 -- End pattern execution