This is a bit of a strange one but the other day in the morning the LEDs in my notification light and keyboard were functioning I noticed yesterday afternoon after installing the power kernel (I reset my device recently just for a fresh start so had to reinstall it) pretty much after that those LED's stopped working. I tried a reflash of PR 1.2. I will prolly do a full flash soon (vanilla image the eMMC aswell). Has anyone experienced this before if it was just the notification light I'd believe it to be hardware but its funny how my keyboards backlights and that are not functioning suddenly.

Thanks in Advance

while flashing.. did u turn on the R&D mode thru command line? if yes turn it off

I don't believe so generally I load up Maemo Flasher 3.5 and then enter.

"flasher-3.5 -F firmware.bin -f -R"

I'll be using the same command for eMMC so for examples sake.

"flasher-3.5 -F emmc.bin -f -R"

ah just looked it up in documentation. And no I have never run that command

have done full flash including eMMC now.. must be hardware I guess :\

Nevermind fixed. All I had to do was remove and re-insert that battery. I feel like an idiot now. lol