[120003.890625] usb 1-1: usb_disable_device nuking all URBs
[120003.890625] usb 1-1: unregistering interface 1-1:1.0
[120003.890625] usbdev1.3_ep81: ep_device_release called for usbdev1.3_ep81
[120003.890625] usbdev1.3_ep02: ep_device_release called for usbdev1.3_ep02
[120003.890625] usb 1-1:1.0: uevent
[120003.890625] usbdev1.3_ep00: ep_device_release called for usbdev1.3_ep00
[120003.890625] usb 1-1: uevent
[120004.023437] scsi 1:0:0:0: rejecting I/O to dead device
[120004.023437] scsi 1:0:0:0: rejecting I/O to dead device
[120004.039062] scsi 1:0:0:0: rejecting I/O to dead device
[120004.039062] scsi 1:0:0:0: rejecting I/O to dead device
[120004.039062] scsi 1:0:0:0: rejecting I/O to dead device
[120004.039062] scsi 1:0:0:0: rejecting I/O to dead device
[120005.890625] hub 1-0:1.0: hub_suspend
[120005.890625] usb usb1: usb auto-suspend
[120153.250000] EAC mode: play enabled, rec enabled
[120155.953125] EAC mode: play disabled, rec disabled
[120174.671875] menelaus 1-0072: Setting voltage 'VMMC' to 3000 mV (reg 0x0a, val 0xb8)
[120179.687500] menelaus 1-0072: Setting voltage 'VMMC' to 3000 mV (reg 0x0a, val 0xb8)
[120200.515625] EAC mode: play enabled, rec enabled
[120203.406250] EAC mode: play disabled, rec disabled
[125719.320312] tusb_source_power 629: VBUS a_wait_vrise, devctl 81 otg 184 conf c0010001 prcm 00a80500
[125719.593750] musb_stage0_irq 646: CONNECT (a_host) devctl 5d
[125719.593750] hub 1-0:1.0: state 8 ports 1 chg 0000 evt 0000
[125719.593750] usb usb1: usb auto-resume
[125719.593750] usb usb1: finish resume
[125719.593750] hub 1-0:1.0: hub_resume
[125719.617187] hub 1-0:1.0: port 1, status 0101, change 0001, 12 Mb/s
[125719.773437] hub 1-0:1.0: debounce: port 1: total 100ms stable 100ms status 0x101
[125719.898437] usb 1-1: new high speed USB device using musb_hdrc and address 4
[125720.070312] usb 1-1: default language 0x0409
[125720.070312] usb 1-1: new device strings: Mfr=1, Product=2, SerialNumber=3
[125720.070312] usb 1-1: Product: USB Mass Storage Device
[125720.070312] usb 1-1: Manufacturer: TSST corp
[125720.070312] usb 1-1: SerialNumber: SET084MP00000002A01
[125720.070312] usb 1-1: device v0409 p0840 is not supported
[125720.070312] usb 1-1: uevent
[125720.070312] usb 1-1: usb_probe_device
[125720.070312] usb 1-1: configuration #1 chosen from 1 choice
[125720.570312] usb 1-1: adding 1-1:1.0 (config #1, interface 0)
[125720.578125] usb 1-1:1.0: uevent
[125720.578125] usb-storage 1-1:1.0: usb_probe_interface
[125720.578125] usb-storage 1-1:1.0: usb_probe_interface - got id
[125720.593750] scsi2 : SCSI emulation for USB Mass Storage devices
[125720.601562] drivers/usb/core/inode.c: creating file '004'
[125720.601562] hub 1-0:1.0: 198mA power budget left
[125720.601562] hub 1-0:1.0: state 7 ports 1 chg 0000 evt 0002
[125720.601562] hub 1-0:1.0: port 1 enable change, status 00000503
[125720.601562] usb-storage: device found at 4
[125720.601562] usb-storage: waiting for device to settle before scanning
[125724.359375] EAC mode: play enabled, rec enabled
[125725.617187] scsi 2:0:0:0: CD-ROM TSSTcorp CD/DVDW SE-T084L TS00 PQ: 0 ANSI: 0
[125726.242187] sr0: scsi3-mmc drive: 6x/24x writer dvd-ram cd/rw xa/form2 cdda tray
[125726.242187] sr 2:0:0:0: Attached scsi CD-ROM sr0
[125726.242187] sr 2:0:0:0: Attached scsi generic sg0 type 5
[125726.265625] usb-storage: device scan complete
[125727.062500] EAC mode: play disabled, rec disabled
[125828.945312] menelaus 1-0072: Setting voltage 'VMMC' to 3000 mV (reg 0x0a, val 0xb8)
[125833.960937] menelaus 1-0072: Setting voltage 'VMMC' to 3000 mV (reg 0x0a, val 0xb8)
[125904.039062] EAC mode: play enabled, rec enabled
[125906.742187] EAC mode: play disabled, rec disabled