Active Topics

 


Reply
Thread Tools
Posts: 2,154 | Thanked: 8,464 times | Joined on May 2010
#1
Hello, battery in my N950 was for 3 years dead and I finally brought a new original Nokia BL-4D. I put it into my N950, it light up but showed me only error message that Device not working properly and that I should contact Nokia Care. There is _no_ security error message which was visible after messing aegis. Note that device worked fine 3 or 4 years ago with previous battery. It had official PR 1.2 release. Is there any way to make N950 working again? I have tried to enable R&D mode and disabling lifeguard reset but it had no effect.
 

The Following User Says Thank You to pali For This Useful Post:
Posts: 263 | Thanked: 301 times | Joined on Oct 2021 @ Poland
#2
Probably reflashing would help... but after messing with mine N950 after simple flashing and breaking it, I would be very careful.
__________________
My Telegram group (Maemo / MeeGo / Sailfish):
https://t.me/linuxmobile_world
Channel for Maemo/MeeGo:
https://t.me/maemomeegoapps
 
Posts: 2,154 | Thanked: 8,464 times | Joined on May 2010
#3
Yea, I do not want to try refleshing because n9/n950 can be easily more broken...

Anyway this is the current state:
Code:
$ 0xFFFF -I
0xFFFF v0.10  // Open Free Fiasco Firmware Flasher

Not a local device

Waiting for USB device...  
Found USB device: SU-18/RX-34/RX-44/RX-48/RX-51/RM-680/RM-696 (0x421:0x105) in NOLO mode
USB device product string: N950 (Update mode)
USB device serial number string: 357881040011522
Detected USB device: RM-680           

Initializing NOLO...
Device: RM-680
HW revision: 1124
NOLO version: 2.3.6
Kernel version: 2.6.32-20115101+0m7
Initfs version: (not detected)
Software release version: DFL61_HARMATTAN_3.2012.02-6_PR_RM680
Content eMMC version: DFL61_HARMATTAN_3.2012.02-6.RM680
Error: Cannot get root device
Root device: (not detected)
USB host mode: disabled
R&D mode: disabled
 

The Following User Says Thank You to pali For This Useful Post:
Halftux's Avatar
Posts: 868 | Thanked: 2,516 times | Joined on Feb 2012 @ Germany
#4
Here the 0xFFFF output of a working N950 PR1.3 as comparison.
Started 0xFFFF and connected then the phone in off state with usb (with original Nokia cable short version CA-101D).


Code:
0xFFFF v0.10  // Open Free Fiasco Firmware Flasher

Not a local device

Waiting for USB device...  
Found USB device: RX-51/RM-680/RM-696 (0x421:0x106) in Cold flashing mode
USB device product string: Nokia USB ROM
USB device serial number string: (not detected)
Detected USB device: (not detected)   

Waiting for ASIC ID...
Detected OMAP3630 chip (revision 7)
Device: (not detected)
HW revision: (not detected)
NOLO version: (not detected)
Kernel version: (not detected)
Initfs version: (not detected)
Software release version: (not detected)
Content eMMC version: (not detected)
Root device: (not detected)
USB host mode: (not detected)
R&D mode: (not detected)
Sending OMAP memory boot message...

Waiting for USB device...  
Found USB device: SU-18/RX-34/RX-44/RX-48/RX-51/RM-680/RM-696 (0x421:0x105) in NOLO mode
USB device product string: N950 (Update mode)
USB device serial number string: 357881040017503
Detected USB device: RM-680           

Initializing NOLO...
Device: RM-680
HW revision: 1124
NOLO version: 2.3.6
Kernel version: 2.6.32-20121301+0m8
Initfs version: (not detected)
Software release version: DFL61_HARMATTAN_40.2012.21-3_PR_RM680
Content eMMC version: DFL61_HARMATTAN_3.2012.02-6.RM680
Error: Cannot get root device
Root device: (not detected)
USB host mode: disabled
R&D mode: enabled
R&D flags: serial-console
 

The Following User Says Thank You to Halftux For This Useful Post:
Reply


 
Forum Jump


All times are GMT. The time now is 08:54.